Your cart is empty
Mfg Item #: 90807
Lee's Carbide Factory Crimp Die sizes the cartridge while being crimped so every round will positively chamber freely with factory like dependability. This die applies a roll style crimp. The adjusting screw quickly and easily sets the desired amount of crimp. Trim Length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered. A firm crimp is essential for dependable and accurate ammunition, as it eliminates the problems of poor ignition of slow burning magnum powders.
| Type | CARBIDE FACTORY |
|---|---|
| Width | 1.7000 |
| Height | 1.6000 |
| Length | 4.7000 |
| Caliber | 9x18mm makarov |
| Dimension | 1.60 X 1.70 X 4.70 |
| Carbide Yn | Y |
| Of Dies In A Set | 1 |
Disclaimer: "GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK Ges.mbH. This site is not affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.mbH. The use of "GLOCK" on this page is merely to advertise accessories For GLOCK pistols including genuine GLOCK, Inc. and GLOCK Ges.mbH products.
